Installation manual of ecg workstation

I. hardware installation of ecg workstation:

1. Put the host computer, monitor, ecg amplifier and printer on a stable working table.

2. One end of the earth wire shall be well grounded (according to the grounding standard of medical instruments), and the other end shall be connected with the terminal post on the back panel of the main machine.Monitor manufacturers

3. Connect the main machine, ecg amplifier and printer power cord to the multi-function power socket.

4. The power cord of the display is connected to the power outlet on the back of the main machine or on the multi-function power socket, and the signal cable of the display is connected to the d-type power outlet of the display card of the main machine. After the connection, tighten the interface screw to ensure no looseness.Monitor manufacturers

5. The printer cable is connected on the back of the host in parallel or on the USB output port. Tighten the screws after the connection to ensure no loosening.

6. Connect the mouse cable to the green circular interface on the back of the host.

7. Plug the USB port or COM port plug of the ecg amplifier into the corresponding interface on the back panel of the computer. The COM port amplifier should be connected to the PS/2 port of the computer, and the keyboard should be connected to the PS/2 port extended by the ecg amplifier.

8. Insert the dongle into the corresponding interface of the back panel of the computer and tighten the screw.

Reminder: remind the installer to check the ground wire after the installation of the system hardware to ensure that the system shell is well grounded. Ground wire is related to the quality of waveform, special ground wire should be more than 1 meter underground, if the waveform drift or instability, should first check whether the ground wire is in good contact.

Ii. Installation of ecg workstation software

1. After the completion of hardware connection check, connect the power supply and start the computer.

2. Install WINDOWS2000 professional operating system. Note: hard disk partition must be more than three.

3. Install OFFICE2000, WINDOWS2000SP4, DIRECTX9 and other system software.

4. Load all device drivers.

5. Put the medex-mecg-200 installation disc (or a backup of the installation program on the hard disk) into the optical disk drive, perform setup. EXE to install the program, and follow the prompts to operate. All the options follow the default value. Restart the computer when you are finished.